IEI 212I KEYPAD TROUBLESHOOTING MAGNET FREE

This warranty shall expire two years after shipping date for DOOR-GARD keypads.Įxcept as stated above, IEI makes no warranties, either express or implied, as to any matter whatsoever, including, without limitation to, the condition of its products, their merchantability, or fitness for any particular purpose. IEI will not be liable to the purchaser or anyone else for incidental or consequential damages arising from any defect in, or malfunction of, its products. IEI’s sole liability is limited to the repair or (at IEI’s option) the replacement of the defective product or part when sent to IEI’s facility (freight and insurance charges prepaid), after first obtaining IEI’s Return Merchandise Authorization. IEI does not assume any responsibility for damage or injury to person or property due to improper care, storage, handling, abuse, misuse, normal wear and tear, or an act of God.

IEI 212I KEYPAD TROUBLESHOOTING MAGNET FREE

(IEI) warrants its products to be free from defects in material and workmanship, when they have been installed in accordance with the manufacturer’s instructions, and have not been modified or tampered with. On SE keypad, holes have also been spotted inside the front housing for additional LEDs (LEDs not included).To speed installation of the SE keypad, holes have been spotted on the inside the back housing for mounting to a wall or a single-gang electrical box.For use in extreme weather conditions, consult the factory for additional methods of protecting your keypad.This allows air to circulate and a place for condensation to drain. Do not seal the drain holes at the bottom of the keypad housing.

Use the template on the back page to accurately mark the mounting holes before drilling. Do not silicone the cover plate because the unit will not seal properly. 212iLM Keypad Installation & Programming Keypad Installation Procedure: Step 1: Drill through the back plate using a 11/64 bit. This helps prevent water from entering the case and condensing on the circuit board.

When mounting this unit outside, apply silicone to the area where the wires enter the case.

The bi-color LED provided with the SE keypad illuminates red when the LockRelease relay is de-energized and green when the relay is de-energized.

To avoid ESD (Electro-Static Discharge) interfering with the operation of the keypad, ground the housing to earth ground.

Iei 212i keypad troubleshooting magnet